Hello, everyone! Today we have a Mercedes CLS 3.0 CDI 2008 diesel 220 ECU, and want to use Foxflash ECU Programmer to clone and do EGR & FLAPS off.
We do the pinout of the EDC16CP31 on its six wires it is connected
We have the pinout below.
I’ve already connected everything.
Turn on the power
Run foxflash software, select Mercedes>> MPC563\4-Mercedes>> EDC16CP31
Click OK
First click Connect
It will ask you to turn off the ignition
Internet connection Internet available
Turn on… So everything joined
We need to calculate Flash and micro.
Then click Read Ext Flash
This is how we write Mercedes CLS. It’s original.
Click Save to save the data
Next click Read Int Flash Micro
Click Save to save the micro (eeprom) data as well
After that, click Davinci-EGR_DPF_DTC.exe
Select the original ext flash data just saved
Detect successfully
Continue to turn off EGR and FLAPS
Deactivate successfully as well
Save the file
Click LSuite.exe
Select the EGR_FLAPS file just deactivated, and click Run
Recalculated successfully
Click Save to save this file
Finally, back to foxflash software to write ext flash
Select the EGR_FLAPS file just recalculated to write
Checksum computed in writing, no need to correct
Click No and wait the ECU writing is successful.
Done!
Tech support:
Skype: foxflash.co.uk
Whatapp: +86 152 7181 3909
foxFlash official site:https://www.foxflash.co.uk